Car LED Strip Lights, 2Pcs 24 Inch Flexible LED Headlight Strips Dual Color White Turn Signal Yellow Lights Waterproof Car Daytime Running Light Strip For Truck SUV

CARLITS DRL LED STRIP Real shot from us Our lights are brighter. Each light bar has more than 100 white and yellow light leds, and there is no dark area. Real shot from customers Sequential turn signal light 01 Yellow light 1th step Sequential turn signal light 02 Yellow light 2th step Sequential turn signal light 03 Yellow light 3th step DRL white light Customer said: 'This product didnt have any reviews, but I thought I'd give it a try as I like that its slim ne how the light beam comes from the side vs the top. I was initially going to install it inside my headlight, but my headlight eyebrow is attached to both my height and turn signal lens and I was concerned it might break trying to remove it. I went with the other option which this product also recommend which is to install it between the headlight housing and the hood. It actually fit really good and you dont notice it when close up to the car when light is off. You want it to run towards the side you are turning.' Can be cut as you need Measure the size before installation, and then cut the appropriate size. Note. Re-attach the plug with glue. Installation suggestions from my customer Install and wiring notes: I decided to use and installed a 'fuse tap - 10 amps max' (see pic 2) on to my existing ACC fuse. I used velcro to keep the wires neat and out of the way. Note that each light is around 1amp, so a very fractional amount of amperage needed. The LED light wires (black) were spliced/soldered to 18 gauge black-colored primary wire and ran to the negative battery cable frame bolt and connected to the bolt with circular terminals. The LED light wires (yellow) were spliced/soldered to the turn signal light positive cable, to allow for the synchronized turn flashes. If necessary, you can use glue to assist the installation, which is more reliable. As many have said, they are not bright during the day, but I use them as a DRL and love the way they look during hours of low light or dark. No fault to the light, but I was unable to use the sequential turn signal, due to my truck having LED and no where for me to tap that wire into. A perfect way to add a stunning custom look to your headlights BENDS TO YOUR WILL: Can be bent, twisted, and contoured to fit most headlights Simply splice into your current DRL and turn signal wiring 60cm in Length,and Cuttable every 3LED Beads (must seal the tube with Insulated Glue for Waterproof Protection)